Research Progresses on Surface Integrity of Bearing Grooves

WANG Dongfeng et al (2143)

Simulation and Experimental Research about Temperature Fields of PDMS Cooled by Liquid Nitrogen Jet Impingement

LIU Xu et al (2161)

Anti-vibration Design for Compressor Pipelines of Inverter Air Conditioners Based on Particle Damping

ZHANG Hongquan et al (2172)

A Kinematic-parameter Calibration Method of Robots Based on Tool Coordinate

GAO Wenbin et al (2183)

Investigation of Deformation Mechanism and Suppression Method of Weak Stiffness Components by Magnetorheological Finishing

PAN Bo et al (2190)

Experimental Research and Analysis on Torsional Fatigue Strength of Engine Crankshafts

CONG Jianchen et al (2197)

Study on Turning Performance of GCr15 Steels with Nanofluids Prepared by Composites of MWCNTs and Oleic Acid

GUAN Jiju et al (2205)

An Energy Efficiency Optimization Model of Fused Filament Fabrication 3D Printing Based on Support Vector Regression

BAO Hong et al (2215)

Analysis of a Full Hydraulic Power Steering System with Integrated Power Regeneration Module

ZHOU Xin et al (2227)

Experimental Study of Micro Scale Mechanics Behavior of Cleavable Gallium Oxide Crystals

XU Yameng et al (2234)

Recession of Elastic Modulus and Prediction of Springback for 7075 Aluminum Alloy Sheets

YANG Zhuoyun et al (2241)

Simulation Analysis and Experimental Study of Stiffness Characteristics of Aero-engine Spline Couplings

LI Lunxu et al (2249)

Three Dimensional Dynamics Behaviors of Rod-cone Collisions with On-orbit Re-placement Units

YOU Bindi et al (2258)