胡記超,王丹東,王雨風,陳亮,陳江平?,2
(1-上海交通大學機械與動力工程學院,上海 200240;2-上海市高效冷卻系統工程技術中心,上海 200240)
使用噴射器代替?zhèn)鹘y(tǒng)制冷系統中的膨脹閥,可以有效回收節流損失,提升系統性能[1-3]。氣液分離器作為噴射式制冷系統的一個關鍵部件,其分離效率和壓降特性對系統性能有著很大影響。
噴射式制冷循環的工作循環為:冷凝器出口制冷劑進入噴射器的噴嘴內增速降壓,引射蒸發器出口的氣態制冷劑,混合后進入擴壓段減速升壓;之后制冷劑進入氣液分離器,氣液分離后氣體進入壓縮機,液體節流后進入蒸發器,蒸發后再作為引射流體進入噴射器[4-9]。R410A噴射式制冷循環的流程[10]和lgp-h圖,如圖1所示。氣液分離器的分離效率一方面會影響進入蒸發器的制冷劑干度,進而影響制冷量[11-13];同時會影響進入壓縮機的制冷劑干度[14-16],進而影響壓縮機功率。
[1]DISAWAS S,WONGWISES S. Experimental investigation onthe performanceof the refrigeration cycle using a two-phaseejector as an expansion device[J].International Journal of Refrigeration, 2004, 27:587-594.
[2]ELBEL S, HRNJAK P. Experimental validation of a prototype ejector designed to reduce throttling losses encountered in transcritical R744 system operation[J].International Journal of Refrigeration, 2008, 31(3):411-422.
[3]LEE J S, KIM M S, KIM M S. Experimental study on theimprovement of CO2air conditioning system performanceusing an ejector[J]. International Journal of Refrigeration, 2011, 34: 1614-1625.
[4]NAKAGAWA M, MARASIGAN A R, MATSUKAWA T. Experimental analysis on the effect of internal heat exchanger in transcritical CO2refrigeration cycle with two-phase ejector[J]. International Journal of Refrigeration, 2011, 34(7): 1577-1586.
[5]TAKEUCHI H, NISHIJIMA H, IKEMOTO T. World's First High Efficiency Refrigeration Cycle with Two-Phase Ejector: “Ejector Cycle”[C]// SAE 2004 World Congress and Exhibition, 2004.
[6]TUO H, BIELSKUS A, HRNJAK P. Effect of flash gas bypass on the performance of R134a mobile air-conditioning system with microchannel evaporator[J].SAE International Journal of Materials and Manufacturing, 2011, 4(1): 231-239.
[7]何曙, 李勇, 王如竹. 噴射器理論研究進展[J]. 低溫與超導, 2008, 36(11): 37-39.
[8]吳迎文, 梁祥飛, 鄭波, 等. 單相噴射器內二維流場數值模擬與結構設計[J]. 制冷技術, 2013, 33(3): 52-55.
[9]熊杰, 王如竹, EIKEVIK T M. 基于單相R744噴射器系統的引射比計算模型及其實驗驗證[J]. 制冷技術,2015, 35(2): 1-7.
[10]郭興龍, 宋新南, 胡自成. 膨脹機與噴射器跨臨界二氧化碳循環比較研究[J]. 制冷技術, 2012, 32(2): 57-60.
[11]池本徹, 武內裕嗣, 西山鳥, 等. 新型噴射循環(Eject Cycle)車用冷凍機的開發[J]. 制冷技術, 2008, 28(1):19-26.
[12]山田悅久, 西嶋春幸, 松井秀也, 等. 小型貨車用噴射式冷凍機[J]. 制冷技術, 2010, 30(2): 35-39.
[13]戚大威, 柳建華, 張良, 等. 蒸汽壓縮/噴射制冷系統噴射器設計及節能分析[J]. 制冷學報, 2014, 35(1):103-108.
[14]傅豐, 趙在三, 郁鴻凌. 氣液兩相流體干度測量的研究與發展[J]. 動力工程, 1991, 11(3): 51-59.
[15]張海鵬, 龔圣捷, 趙彥青, 等. 混合法測量蒸汽干度[J].計量技術, 2004(2): 6-7.
[16]楊方, 韓玉生. 測量和控制蒸汽干度的方法[J]. 國外石油機械, 1994, 5(1): 63-67.
[17]吳騰飛, 臧潤清, 劉江彬. 再循環重力供液系統氣液分離理論分析[J]. 制冷技術, 2013, 33(3): 39-41.
[18]周華, 夏南. 氣分離器內氣液兩相流的數值模擬[J].計算力學學報, 2006, 23(6): 766-771.
[19]MOVAFAGHIAN S, JAUA-MARTURET J A, MOHAN R S, et al. The effects of geometry, fluid properties and pressure on the hydrodynamics of gas-liquid cylindrical cyclone separators[J]. International Journal of Multiphase Flow, 2000, 26(6): 999-1018.
[20]MA L, INGHAM D B, WEN X. Numerical modelling of the fluid and particle penetration through small sampling cyclones[J]. Journal of Aerosol Science, 2000, 31(9):1097-1119.
[21]YANG I H, SHIN C B, KIM T H, et al. A three dimensional simulation of a hydrocyclone for the sludge separation water purifying plants and comparison with experimental data[J]. Minerals Engineering, 2004, 17:637-641.
[22]吳春篤, 張偉, 黃勇強, 等. 新型旋流分離器內固液兩相流的數值模擬[J]. 農業工程學報, 2006, 22(2):98-102.