亚洲免费av电影一区二区三区,日韩爱爱视频,51精品视频一区二区三区,91视频爱爱,日韩欧美在线播放视频,中文字幕少妇AV,亚洲电影中文字幕,久久久久亚洲av成人网址,久久综合视频网站,国产在线不卡免费播放

        ?

        Test and Analysis for Spraying Ammonia in Diesel Engine

        2011-07-25 06:21:40ZHOUHuaxiang周華祥LIUJingping劉敬平HELike賀力克CHENFang陳方SHENQizhi申奇志LUORui駱銳ZHOUZheng周正
        Defence Technology 2011年4期
        關鍵詞:陳方奇志周正

        ZHOU Hua-xiang(周華祥),LIU Jing-ping(劉敬平),HE Li-ke(賀力克),CHEN Fang(陳方),SHEN Qi-zhi(申奇志),LUO Rui(駱銳),ZHOU Zheng(周正)

        (1.Key Laboratory of Internal Combustion Engine,Hunan University,Changsha 410082,Hunan,China;2.Automotive Engineering Institute,Hunan Industry Polytechnic,Changsha 410007,Hunan,China;3.Changsha Zoomlion Heavy Industry Science and Technology Development Co.,Ltd.Changsha 410013,Hunan,China)

        Introduction

        To reduce NOxin emissions to meet EuropeanⅤstandard and not to decrease the thermal efficiency of diesel engines is an important and difficult problem in current emission researches[2-4].Directly spraying the ammonia reducer into the engine cylinder,in the absence of catalyst conditions,may be a feasible method to solve this problem.When the combustion temperature in the engine decreases into the range in which the ammonia reducer can react effectively,the ammonia reducer may be injected into the combustion gas.It can effectively reduce the levels of NO in emission,generate harmless N2and H2O,and does not decrease the engine’s thermal efficiency.The test in engine 4102BZLQ verifies the technical feasibility.

        1 Test Mode of Spraying Ammonia in Diesel Engine

        A typical diesel engine 4102BZLQ is used in the test.Behind the compression TDC(360°CA),the engine ignites and works,and when the gas temperature drops to 1 573 K,the ammonia reducer can be injected directly into the cylinder,as shown in Fig.1.

        Fig.1 Injection mode for fuel and ammonia reducer

        2 Test Scheme

        The engine’s main technical parameters are shown in Tab.1.

        In the test,the original parameters of the engine keep no change.The ammonia injection and electronic control systems are installed on the cylinder head.Injection point is set to 20°CA -90°CA after compression top dead and controllable.The injection volume of am-monia can be determined according to the molar ratio NOx/NH3of 1∶3.3,and controlled according to the typical and excessive conditions.The pressure of industrial bottled ammonia is 10-22 MPa.The sketch of test and detection scheme is shown in Fig.2.

        Tab.1 Main parameters of engine typed 4102BZLQ

        Fig.2 Sketch of test scheme

        3 Test Apparatus

        1)Hydraulic power dynamometer typed by Y120-S with the max power of 120 kW and the max speed of 7 500 r/min;

        2)Discharging analyzer typed by AVL DiGas4000 with measurement range of 0-5 000 ppm and accuracy of 1 ppm;

        3)Transient fuel consumption meter typed by FCM07 with bandwidth of 0.5 Hz,data update rate of 1 Hz and accuracy of 2%FS in the transient fuel consumption rate and 0.5%in the average fuel consumption rate;

        4)Data acquisition board typed by AT-MIO-16E-2 with software LabView;

        5)Fiber temperature sensor typed by H-G-3-A with measurement range of 623-3 273 K,accuracy of±0.5%,repeatability of±0.1%and response time of 10 ms;

        6)Pressure sensor typed by PT702 with measurement range of 0-20 MPa and accuracy of 0.5%FS;

        7)Homemade multi-function electric injector;

        8)Oxygen sensor typed by O2S-FR-T2-18X.

        4 Test Method

        4.1 Determination of Ammonia Injection Timing[5 -6]

        The volume of NOxgenerated in 4102BZLQ engine’s cylinder is measured in different crank angles,as shown in Fig.3.The point,at which NOxproduces rapidly,corresponds to the crank angle of 361°CA.In Fig.4 indicating the measured average temperature,it corresponds to the temperature of 1 700 K.

        Fig.3 NOx in different crank angles

        Based on the detailed PRF fuel mechanism given by Lawrance Livermore National Laboratory and Zeldovich theory,the main chemical reaction equations on the thermal NOxformation can be written as

        whereK1,K-1,K2andK-2denote the reaction rate constants in the forward and reverse reactions.Tab.2 shows these measured reaction rate constants.

        Tab.2 Measured reaction rate constants

        The measured effective reaction temperature of ammonia ranges from 1 573 K to 1 073 K,thus,when the combustion chamber temperature reduces into this range,the ammonia can be injected into the chamber to react with NOxeffectively.In the test,the spraying start point and volume are determined according to the conditions and emission control standards.For 4102BZLQ engine,the best spraying start point corresponds to the temperature of 1 273 K,and it can obtain better thermal efficiency and purification effect.That is,when the combustion temperature reduces to 1 273 K,the reducer ammonia can be injected into the chamber.The crank angle,that is,448°CA,corresponding to 1 273 K can be found in the average temperature curve shown in Fig.4.

        Fig.4 Average temperature curve

        4.2 Determinations of Injection Pressure and Volume

        The measured average pressure curve of 4102BZLQ engine can be used to determine the injection pressure and volume,as shown in Fig.5.The cylinder pressure corresponding to 1 273 K and 448°CA is 1.2 MPa.Thus,the ammonia injection pressure can be taken as 12 MPa.The ammonia injection volume can be determined according to the molar ratio of 1∶3.3 for NOxand NH3.These data can all be written in the control program.

        Fig.5 Average pressure

        Tab.3 Basic ammonia spraying angle and volume of 4102BZLQ engine

        4.3 Experiment Results and Analyses[7-8]

        The experiment results show that the spraying of reducer ammonia in appropriate time can effectively reduce NOxin the exhaust composition.NOxvolume generated in the diesel engine without ammonia spraying is of 3.7 g/(kW·h),equivalent to EuroⅢ standards.Spraying ammonia in 451°CA and 1 237 K,NO volume can be reduced to 1.11 g/(kW·h),less than EuroⅤstandard,2.0 g/(kW·h).Meanwhile,NOx,in about 20°CA generates rapidly,and its concentration keeps no change after reaching a certain value.In the diesel combustion process,in 347°CA,the cylinder tempera-ture is 1 030 K;in 351°CA,the diesel begins to fire,and the temperature rises sharply;in 365.4°CA,the cylinder pressure reaches to the maximum,12.74 MPa;in 376°CA,the temperature inside the cylinder is up the maximum,1 763 K;in 451°CA,the temperature reduces to 1 237 K.

        The emission test results in thirteen ESC conditions are listed in Tab.4.

        Tab.4 Emission test results

        The effective power and fuel consumption with and without ammonia spraying are shown in Tab.5.

        Tab.5 Effective power and fuel consumption in different conditions

        5 Conclusions

        1)In the appropriate time,the ammonia injection to the diesel engine can effectively reduce NOxin the combustion gas,and the EuroⅤ standard could be reached.

        2)Spraying ammonia in diesel engine can avoid to use the catalyst,eliminate the catalyst sinter,alkali metal and arsenic poisoning,and gas erosion,and increase the purification effect.It greatly simplifies the engine’s purification system also.And,it does not limit the diesel’s combustion temperature and influence the engine’s thermal efficiency.

        [1]XU Yun,LIU Zhong-chang,HAN Yong-qiang.Comparison of test cycle of 13 conditions and European steadystate test cycle to evaluate heavy-duty diesel engine emissions[J].Automotive Engineering,2003,(1):46 -48.(in Chinese)

        [2]LENG Xian-yin,LONG Wu-qiang.Modern purification technology for NOxemissions of marine diesel engine[J].Diesel,2009,31(2):19 -25.(in Chinese)

        [3]MAO Xiao-jian,LOU Cheng-wei,XIAO Wen-yong.Key technologies satisfying future emission regulations for car’s diesel engine[J].Vehicle Engine,2006,(2):6 -14.(in Chinese)

        [4]XU Yang.Technical scheme of exhaust post-processing for diesel based on regulations of EURO Ⅲ above[J].Journal of Wuhan University of Technology,2006,(8):34-37.(in Chinese)

        [5]DU Jian-bo,WANG Zhen,F(xiàn)ANG Mao-dong.Post-processing for diesel car to meet new emission regulations[J].Shanghai Automobile,2006,(4):40 - 43.(in Chinese)

        [6]LIAO Shi-yong,JIANG De-ming.Research progress and problems on post-processing technology for diesel exhaust[J].Internal Combustion Engine,2002,(3):3 - 6.(in Chinese)

        [7]MAO Xiao-jian,XIAO Wen-yong,ZHOU Xing-li.Exploration on technical measures for diesel cars[J].Automotive Engineering,2006,(7):611 -617.(in Chinese)

        [8]LIANG Hong,LIN Wei-ming.Research on emission control technology for diesel engines[J].Guangdong Chemical Industry,2004,(6):28-30.(in Chinese)

        猜你喜歡
        陳方奇志周正
        On-surface synthesis of one-dimensional carbyne-like nanostructures with sp-carbon
        Quench dynamics in 1D model with 3rd-nearest-neighbor hoppings?
        李偉賢、葉子康、周已程、周正男作品
        大觀(2020年9期)2020-01-25 16:24:08
        西門警事之四十一
        派出所工作(2018年5期)2018-09-10 23:34:39
        西門警事之三十七
        派出所工作(2018年1期)2018-05-30 17:06:09
        勻變速直線運動規律應用中的一類典型易錯題
        王奇志花鳥畫作品欣賞
        西門警事之二十六
        派出所工作(2017年2期)2017-05-30 22:28:06
        王奇志花鳥畫作品欣賞
        湖湘論壇(2017年2期)2017-03-20 10:08:44
        LAND OF RAZOR CLAMS
        正在播放国产多p交换视频| 久久精见国产亚洲av高清热| 国产精品女人一区二区三区| 人妻被黑人粗大的猛烈进出 | 在线永久免费观看黄网站| 中文字幕无码家庭乱欲| 午夜短视频日韩免费| 色www亚洲| 久久亚洲成a人片| 国产高清一区在线观看| 亚洲一区二区精品在线看| 国产一区二区三区在线观看蜜桃| 久久影院最新国产精品| 国产免费人成视频在线| 亚洲女人毛茸茸粉红大阴户传播 | 午夜裸体性播放| 国产精品欧美一区二区三区不卡| 玩弄少妇高潮ⅹxxxyw| 国产微拍精品一区二区| 3亚洲日韩在线精品区| 日韩精品久久不卡中文字幕| 日本高清视频在线观看一区二区| 精品av熟女一区二区偷窥海滩 | 免费中文熟妇在线影片| 免费a级毛片出奶水| 精品国产高清a毛片| 日本中文字幕一区二区视频| 少妇极品熟妇人妻高清| 风韵人妻丰满熟妇老熟| 插鸡网站在线播放免费观看| 国产精品天堂avav在线| 亚洲色偷拍区另类无码专区| 国产亚洲精选美女久久久久| 国产自拍av在线观看| 激情精品一区二区三区| 国产色欲av一区二区三区| 国产一极内射視颍一| 无码专区久久综合久中文字幕 | 精品无码国产一二三区麻豆| 新视觉亚洲三区二区一区理伦| 国产乱人无码伦av在线a|